For Professional Use Only
WARNING: Avoid exposure to vapors. Use in a well-ventilated area with an approved respirator device.
For an easier-to-use product with new advanced technology that produces the same results, we recommend BulletProof Sealer or Heavy Duty Sealer
Features + Benefits
- Heavy duty protection against all stains
- Original fluorochemical technology
- Natural look
- Solvent-based, interior & exterior
Where to Use
Natural stone such as marble, granite, limestone, slate, terrazzo, travertine & sandstone. Best suited for the most porous stone surfaces.
Directions
Note: Directions may vary depending on size. Always test in a small inconspicuous area with a 24-hour cure time to determine ease of application and desired results. Allow new grout installations to cure for a minimum of 72 hours prior to application. Make sure surface is clean, dry and free of waxes and coatings.
- Mask off and protect any baseboards or adjacent areas to avoid splashing and overspray onto surfaces not intended to be treated.
- Liberally apply an even coat using a paint pad, low-pressure solvent-resistant sprayer, roller or brush.
- Allow sealer to penetrate the surface for 15-30 minutes; denser material may require more time for sealer to penetrate. During this time, distribute excess over entire area to insure even penetration.
- Thoroughly wipe the entire surface with a clean dry cloth to completely remove all excess Impregnator Pro from the surface. DO NOT ALLOW IMPREGNATOR PRO TO DRY ON THE SURFACE.
- A second coat may be needed for porous, absorbent surfaces and should be applied one hour after initial application as directed in steps 2-3.
- If sealer was not completely wiped off and a residue appears, wipe entire surface with a towel dampened with sealer. Use a white nylon pad to loosen residue and follow with a clean, white absorbent towel to remove.
- A full cure is achieved after 24-72 hours; foot traffic may begin in 6-8 hours. Cover with red rosin paper, if foot traffic must resume before the recommended time periods have passed.
- Clean equipment with mineral spirits.
Available Sizes (and Coverage)
- Pint: 25-200 sq. ft.
- Quart: 50-400 sq. ft.
- Gallon: 200-1,500 sq. ft.
Expected Wear: 3-5 years on interior surfaces & 1-3 years on exterior surfaces.
Copyright 2003 WholesaleTravertine.com. All rights reserved.