Features + Benefits
· Advanced penetrating microbond protection
· Heavy duty protection against all stains
· Makes cleaning stone easier
· Preserves natural look
· Water-based, interior & exterior
Where to Use
Natural stone such as marble, granite, limestone, slate, terrazzo, travertine & sandstone.
Always test in a small inconspicuous area with a 24-hour cure time to determine ease of application and desired results. Allow new grout installations to cure for a minimum of 72 hours prior to application. Make sure surface is clean, dry and free of waxes and coatings.
- Mask off and protect any baseboards or adjacent areas to avoid splashing and overspray onto surfaces not intended to be treated.
- Sealer may be applied to damp surfaces one hour after standing water has been removed.
- Liberally apply an even coat using a paint pad, low-pressure chemical-resistant sprayer, roller or brush.
- Allow sealer to penetrate the surface for 15-30 minutes. During this time, distribute excess over entire area to insure even penetration. Wipe entire surface thoroughly with clean dry towel.
- A second coat may be needed for porous, absorbent surfaces and should be applied 30-40 minutes after initial application as directed in steps 3-4.
- A minimum of 15 minutes after final application, wipe entire surface with a clean dry towel to remove any excess sealer. If needed, dampen white nylon pad with sealer to remove residue and dry again thoroughly with clean dry towel.
- A full cure is achieved after 24-72 hours; foot traffic may begin in 6-8 hours. Cover with red rosin paper, if foot traffic must resume before the recommended time periods have passed.
- Clean equipment with water.
Available Sizes (and Coverage)
- Expected Wear: 3-5 years on interior surfaces & 1-3 years on exterior surfaces.
· Quart: 50-400 sq. ft.
· Gallon: 200-1,000 sq. ft.
BulletProof Sealer
Copyright 2003 WholesaleTravertine.com. All rights reserved.
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
